High-output coils for use in either 2- or 4-cylinder motorcycles. Motorcycles with point or electronically triggered ignitions use PART #140403 or #140403S. Bikes equipped with capacitive discharge ignition (CDI) use PART #140404 or #140404S.ACCEL engineers designed these coils' special low-resistance primary winding to match the operating characteristics of factory and aftermarket CDI systems. Maximum performance with fast rise times. Extra-heavy-duty 8.8mm silicone wires included. NOTE: Using the wrong coil may damage your motorcycle's electronic ignition module. To determine your ignition type, complete the following test.
Determine whether the type of coil you are replacing is a high tower coil. These coils will NOT replace single tower coils.Using a volt meter or 12V test light, hook the positive lead to the positive post and the negative lead to the ground on one of the stock coils. Turn the ignition on, but DO NOT engage the starter button. If there are 12V at the coil, the motorcycle has an inductive type ignition. If there is no voltage at the coil, then the motorcycle has a CDI ignition because the power goes to the control box first.
Photos are shown for reference only. Parts may be different in look, depending on your model and year.
This product is made to fit the models and years listed in the description, regardless of the photo. Photo is for reference only. Some products may vary in appearance based on your model/year.Although appearance may vary, this product is made to fit the application listed in the listing description (see fitment section). Product(s) will NOT be accepted if the product has been damaged, installed, or altered in any way. The item "Accel Coils Super Kit Blk 3 Ohm 2102-0266" is in sale since Wednesday, December 6, 2017.
This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Electrical & Ignition\Ignition Coils". The seller is "usmotoparts" and is located in La Habra, California. This item can be shipped worldwide.