Super Coil Kit Inductive Discharge High-output coils for use in either 2- or 4-cylinder motorcycles Motorcycles with point or electronically triggered ignitions use PART #140403 or #140403S Bikes equipped with capacitive discharge ignition (CDI) use PART #140404 or #140404S ACCEL engineers designed these coils special low-resistance primary winding to match the operating characteristics of factory and aftermarket CDI systems Maximum performance with fast rise times Extra-heavy-duty 9mm silicone wires included Made in the U. NOTE: Using the wrong coil may damage your motorcycles electronic ignition module.To determine your ignition type, complete the following test: 1. Determine whether the type of coil you are replacing is a high tower coil. These coils will NOT replace single tower coils. Using a volt meter or 12V test light, hook the positive lead to the positive post and the negative lead to the ground on one of the stock coils. Turn the ignition on, but DO NOT engage the starter button. If there are 12V at the coil, the motorcycle has an inductive type ignition. If there is no voltage at the coil, then the motorcycle has a CDI ignition because the power goes to the control box first. 4 Cylinder Model Two Coil Kit Inductive Discharge Ignition Primary Resistance is 3.0 Ohms.
The item "Accel 140403 Super Coil Kit Inductive Discharge 4 Cylinder (Two-Coil)" is in sale since Wednesday, March 30, 2016. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Electrical & Ignition\Ignition Coils".The seller is "powersportsuperstore" and is located in Cedar Park, Texas. This item can be shipped worldwide.